45031 Exposure Head Interface EHI: incorrect light level at start of edge detection - check if plate loaded is too large Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 At the beginning of the edge search, the focus servo has detected that we are on the plate. The edge search algorithm backs up and tries again. If we are still on the plate after EDGE_ATTEMPTS tries, this error message is reported. Ensure the correct plate size is entered for the plate. If it is correct, try selecting RESUME if it is available. If it is not correct, you must cancel this job. This error is reported. The plate size (ssz) is too small. Focus servo not working properly. If you have thermal head version 1.56 it is easily possible to diagnose the exact problem by using the internal data collection capabilities (see release notes or head diag0 information). Head not installed properly. Incorrect edge thresholds. Check the nvs parameters ONTHRESH and OFFTHRESH. 03-Jul-2002 ../prm/ehi_head_onthresh.xmlPRM: head onthresh ../prm/ehi_head_offthresh.xmlPRM: head offthresh ../prm/ehi_head_diag0.xmlPRM: head diag0 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:43 2008 PST